CAS Stud Wall (0.25 inch.1.75 inch.) studded, non-progressive demountable wall system uses a batten system to attach the wall panels to the studs. There are four different framing studs available for this system to allow for single or double sided walls, retrofit to existing walls and/or extensive pipe racking on the chase side. The studs are compatible with Unistrut™ hardware making attachments for mullions and pipe racking easy to install. This system is also compatible with the CAS studless wall system (see below) for a seamless transition, making changes from a studded to studless system quick and easy. Glazed vision panels or return air grilles can be installed as requirements change over the life of the facility.

The unique characteristics of the stud wall system include:

• Non-progressive, demountable design.
• Structural stud performance: uniform load of <L/304 @ 20 lbs./sq. ft.
• Wall panel structural performance: uniform load <L/240 @ 5 lbs./sq. ft.
• By using the structural stud the wall system can support Plenums and RAHU units.
• Can be used to finish cleanrooms over existing gyp board walls.

CAS Studdless Wall (1.75 inch.) studless, non-progressive demountable wall system is less costly than framed systems requiring extra time and materials for framing prior to panel installation. The studless system is comprised of aluminum honeycomb panels and trim that provide sufficient stiffness to meet the most clean manufacturing requirements.  Straightforward design allows for quick and easy installation requiring only the head track and base track be installed before the panels are fit into place. With the optional addition of rotator corners, return air grilles or openings, glazed vision panels and door opening panels the clean envelope is complete and ready for use.

The unique characteristics of the studless wall system include:

• Non-progressive, demountable storefront design.
• Wall panel structural performance: uniform load <L/240 @ 5 lbs./sq. ft.
• Allows for easy penetration to accommodate tool bulk-heading or wafer transport rails.
• Panels are available with internal pipe racking extrusions compatible with Unistrut™ hardware.
• Framing systems for heavily bulk-headed areas.

Network™ 306 (1.750 inch) studless, non-progressive demountable wall system.  This wall is comprised of aluminum honeycomb panels and extruded aluminum trim. The 306 wall is designed for areas where high demountability is required. The 306 wall is capable of spanning 16’-0” high. Formed panels edges and integral gaskets eliminate the need for battens. This curtain wall approach versus a stick-framed wall facilitates quick and easy installation requiring only the head and basetrack be installed prior to panel installation. Flush glazing, retrofit glazing, return-air grilles, bulkheading and integral doors are available.

Network™ 307 (1.750 inch) studless, non-progressive demountable wall system.  This wall is comprised of aluminum honeycomb panels and extruded aluminum trim. The 307 wall is designed for areas where only moderate demountability is required. The 307 wall is capable of spanning 16’-0” high. Formed panels edges and integral gaskets eliminate the need for battens. This curtain wall approach versus a stick-framed wall facilitates quick and easy installation requiring only the head and basetrack be installed prior to panel installation. Flush glazing, retrofit glazing, return-air grilles, bulkheading and integral doors are available.

The unique characteristics of both the 306 and 307 wall systems include:

• Wall heights of 18’-0” (5.5 m) standard, even greater heights using non-standard panels
• Non-progressive, demountable design
• Using the 306 system permits the upper transom panels to remain in place while the bottom panels are removed facilitating equipment move in.
• Integral pipe racking can be formed into the panels
• Conduit penetrations.
• Grounding clips for conductive or static dissipative partitions.

Please contact one of our specialists at CAS to request a no-obligation quote on any of our wall systems.